Measure around the lower portion of the neck (Just under the Adam's apple), where the collar usually sits. Allow two fingers to fit the gap between the tape and your neck.

NOTE: If you are comfortable with your standard collar size, enter that here instead.

Measure around the upper (largest) portion of your chest, just under the armpits. Try to inhale when measuring this will ensure that your measurement account for your chest at its fullest.

Just above the beltline, measure around the fullest part of the waist.

NOTE: This measurement will typically be larger than your pant size.

Measure around the fullest part of your hips, just below the hip bone.

With your arm at your side, measure from the tip of the shoulder to the lower wrist or to the desired length (slighly longer is better than slightly shorter). Perform this for each sleeve to account for any differences in length.

With your arms at your side, measure around your arm (2-3 inches under the armpit). Do not contract your muscles.

Measure around your wrist (at the bone) where a watch would typically be worn. If you wear a large watch add 1/2 inch to the measurement.

Measure accross the back, from one edge of the shoulder to the other. Make sure that you take into account the curved contour of the shoulders (as shown).

Measure from the base of the neck (where the lower collar would be) to the desired length. Typically this is measured to the bottom of the seat.

Traditional

Slim